To compensate for a higher rated capacitor you might
have to add voltage to your machine to get the same
effect. Try changing out your rear spring in conjunction
with changing the cap, you have to remember
that there are a lot of variables involved with tuning a
machine and when you change one thing you are affecting
all other components involved. A good way to
tell that your cap is not rated high enough is that the
machine will quit on you when you apply resistance
(try to bog it down). Keep an eye on the spark that is
flying on the contact point tip when you bog your machine,
this is a good indicator of your cap’s ability.
Capacitor and voltage
feel free to drop us a line [email protected]
-
Needle bar grommets
, Uncategorized, bar, grommet, needle, 0
There are two standard types of needle bar grommets. The first grommet style is the full circle. The full...
-
Used tattoo gear scam
, Uncategorized, buy, buying pro tattoo gear online, purchase, scam, supply, 0
Buyer Beware. There are a lot of tattoo scams on the internet. The only way you can make sure...
-
Wear Gloves when applying stencils
, Uncategorized, application, gloves, stnecil, tattoo, 0
Gloves should be worn during all times of stencil application, and the skin should always be cleaned prior to...
-
Goal Eight
, Uncategorized, goals, 0
Tattoo aftercare is our eighth goal in the succession of this text. If not done properly, the tattoo’s design...
-
-
Newbie confessions
, Uncategorized, apprentice, confession, unsafe, 0
I will attest that I didn’t do a proper tattoo until I apprenticed. I struggled to get ink to...
-
Conversation on the Tattoo Forums
, Uncategorized, machines, tattoo coils, tattoo forum, tattoo wire, 0
Conversation with C.R. Jordan in response to the tattoo forums on TeachMeToTattoo.com/forum Alright so I will go...
-
Materials for wrapping up the tattoo
, Uncategorized, bandage, paper towel, tape, wrap, 0
There are several bandage materials that I have seen used in tattoo studios. The most common is the paper...
Recent Comments