brokenpipe

[brokenpipe]

One of the earlier designes of it. I used three different machines on it. 2 clips and one snap. Did the lining with a hilbrandt with my cord on it. Thanks for the info. It’s sad
I. Liked this forum. Ill be joining you guys shortly

[brokenpipe]

why does no one comment anymore ?? What happened ?

[brokenpipe]

http://i1179.photobucket.com/albums/x382/dominicrivera/Mobile%20Uploads/20140213_195023_zps32d177db.jpg

[brokenpipe]

[img]/img]

[brokenpipe]

Picture is blurry on my phone. Did u draw it on or use a stencil?

[brokenpipe]

Power supply and coil selection is key to running Bigger Grouping. The rest is you and your tune

[brokenpipe]

You don’t have it grounded at the wall!!! And your power supply or clip cord has a short. Are u using a three prong wall outlet? I’m an electrician by trade so this is a common issue with power tools. If your using made in China stuff then you prolly have a bad connection. Quality control is not one of the top priorities. If it was an insulation Washer then your coils would just stay on when u hit the pedal. It’s shocking you because your the only place the power had to get back to the source. Check it out and please let me know what u find

[brokenpipe]

Old is a state of mind lol. Do a few years in the army and tell me you still feel young and spry . I’m in MD and have recently discovered that the shop I paid 40$ for my tatts in its now charging 180 an hour and that’s the lowest rate in town. I’m in the wrong full time work but it has presented an opportunity. I just got a new place closer to Dc. Ive set up a studio and I’m just waiting until nov to buy a real chair. Just thought you guys should know the price game down here in the states. Not sure why it’s so much considering that md had no license for tattoos on the books. They just require you sign paper work before the tatt is done. One day I’ll be in a better position to do this full time and get that money lol

[brokenpipe]

You can get machines all day on ebay and amazon for little to nothing. … Do not use them on flesh. At minimum you need to change the coils and Springs and that’s only assuming you Hey one with passable team geometry. If you can start with hildbrandt . Buy an ebay machine and compare the two. This I think will teach you volumes of dos and donts . Some one on here had a hidden link on machine timing on their page. Find that and check it out

[brokenpipe]

Going to be some time before I can get to the second lesson. Work is picking up and so is class. Im really looking forward to it though.

[brokenpipe]

The trinkets rose is finished. The stem design was just an example.

[brokenpipe]

did i post in the wrong area? Not one reply was made on my pieces . i posted under the original post in the apprentices section

[brokenpipe]

lighter metals would be fine but you need a yolk. they only heat up if your running to high of a duty cycle on your coils

[brokenpipe]

welcome to the family

[brokenpipe]

just put my first submission up

[Author]

Posts