The cold zone is defined as an area that holds your sterile materials.
This area is not to be touched during the tattoo process
at all. For our purposes, the tattoo process begins once the skin
of the client has been broken.
The warm zone is an area that can be touched during the tattoo
process, but only with clean gloves. Clean gloves are gloves
that are on the tattoo artist and have not touched anything in the
hot zone.
The hot zone is the area and equipment that have touched
bodily fluids, or contain other materials that are deemed as
single use and have been set aside for this single application.
Work Area Set-Up
feel free to drop us a line [email protected]
-
Goal Nine
, Uncategorized, goals, 0
How you act, work, and interact in a tattoo studio atmosphere is very important. This aspect is often overlooked...
-
Stuffing the Coils
, Uncategorized, coil, coils, machine, tuing, 4
Coil tattoo machines have wire wrapped coils that are then magnetized and will pull the a-bar down. The coils...
-
Goal One
, Uncategorized, goals, 0
The first thing you have to learn is the sanitation and its relation to the practice of tattooing. Common...
-
Capacitor and voltage
, Uncategorized, capacitor, tune, tuning, voltage, 0
To compensate for a higher rated capacitor you might have to add voltage to your machine to get the...
-
Tutorial – Dracula Black and Gray – Video 001
, Uncategorized, black and gray, clip 001, clip 1, dracula, stencil, tutorial, 2
This is video 1 in .flv format. This video SHOULD STREAM if you have Flash Installed on your Browser....
-
Can a Coin give your rear spring Energy?
, Uncategorized, machine spring, rear spring, tip, tricks, tuning, 0
Often times there will be a deck clamp fastened on top of the rear spring above the rear of...
-
DC current required
, Uncategorized, current, dc, electricity, power, tuning, voltage, 2
Tattoo machines require DC or direct current. Direct current is the unidirectional flow of current. This is opposite the...
-
Contact Relation Triangle – Helps to Tune Machines
, Uncategorized, frame, relation, spring, tuning, 0
Triangle (ABC) starts with point (A) being where the contact point touches the front spring. Triangle (ABC) continues with...
Recent Comments