Often times there will be a deck clamp fastened on top of the
rear spring above the rear of the frame. This deck clamp can be
effective when it is compared to a
circular washer because it will allow
the balance of the energy to
be evenly distributed across the
width of the entire spring instead
of the portion where the peak of
the circular washer resides. An
old school trick that many artists
have adopted was to take a coin
of some sort, and cut it in half.
The coin was then tapped with a
hole in it, and utilized as a deck
clamp. Now there are a lot of manufactures that distribute deck
clamps in a variety of materials.
Can a Coin give your rear spring Energy?
feel free to drop us a line support@TeachMeToTattoo.com
-
Lining with Magnum
, Uncategorized, lining, magnum, mags, needle, 0
Round liner groupings are not the only groupings that are required for tattooing outlines. It is possible to outline...
-
Cap size does matter!
, Uncategorized, capacitor, coil, machine, tuning, 0
Small capacitors can make your tattoo machine run faster. Not small size, but small rating in the micro farads....
-
1.1 Introduction
, Uncategorized, guns, introduction, machines, tattoo kit, 0
In the year 2000 I began my search for adequate materials that would provide not only comprehendible instruction, but...
-
Purchase a Power Supply
, Uncategorized, equipment, gear, power, purchase, supply, 0
The power supply is a key component to any tattoo artist’s arsenal and should never be underestimated. Each piece...
-
Spore Testing Autoclave in a Tattoo Studio
, Uncategorized, autoclave, spore, sterilization, test, 0
According to CDC (Center for Disease Control) guidelines: “If spores are not killed in routine spore tests, the sterilizer...
-
Multi-meter is useful in the tattoo studio
, Uncategorized, fix, help, repair, troubleshooting, tuning, voltage, 0
You should become familiar with a digital voltmeter or multimeter. It is recommended that all tattoo artists own a...
-
Contact Screw Adjustments
, Uncategorized, contact, machine, screw, tuning, 0
Some effects can be achieved simply by tightening the contact screw, or moving its tip closer to the armature...
-
Whats with the capacitor?
, Uncategorized, capacitor, coils, machine, tuning, 0
The capacitor is a very important part of the coils as well. It technically is not part of the...
Recent Comments