Some tattoo power supplies will not display the voltage as in a
digital meter. Typically you will have a ten turn pot style knob on
the tattoo power supply. This means that the knob that controls
the voltage will rotate ten full rotations from zero to max volts.
Each power supply has its own range and variable number of
rotations. You have to refer to the manufacturer to know what
style you have in your possession.
Related Articles
-
Got Talent?
If you do not have an ounce of artistic talent, meaning you can’t even trace a line on paper,...
-
Tattoo Needle Configurations
This is some information from CR Jordan's new DVD Training series for Tattoo Artists. The following is a rough...
-
Diamond Tips for lining
A really good practice to use when outlining is to use diamond tips. Tips are the lower (touches the...
-
Contact Point suggestions…
Like everything else on the tattoo machine, experiment and play around to find out what works best for your...
-
Stuffing the Coils
Coil tattoo machines have wire wrapped coils that are then magnetized and will pull the a-bar down. The coils...
-
Artist Responsibility in the Studio
Sometimes it is hard for artists to remain vigilant in regards to disease and infection prevention. That is why...
-
Tattoo Forum
Tattoo Forum FREE, hosted by Tattoo Books Online and Teach Me To Tattoo. This is a community online website...
-
What is important to know about Chemicals is…
The key thing to know about chemicals is that not all are approved for use with your instruments that...
0 Comments
