As electricity flows through the
tattoo machine it travels around
the coils in the wire, creating an
electro-magnetized core. It is this
magnet that will pull down on the
armature bar and force the needle
into the skin. When the armature
bar is pulled down, the front
spring that is attached to it loses
contact with the front binding
contact screw. When the contact
screw loses contact with the front
spring, the electrical circuit is turned off. While the circuit is off,
there is no electricity flowing through the coils (or a very limited
amount); causing the armature bar to be released from the magnetic
field pulling it down. This obviously will remove the needle
from the skin and complete the cycle.
What do the coils do?
feel free to drop us a line [email protected]
-
Cap size does matter!
, Uncategorized, capacitor, coil, machine, tuning, 0
Small capacitors can make your tattoo machine run faster. Not small size, but small rating in the micro farads....
-
Sumi
, Uncategorized, grey, pigment, shading, sumi, tattoo technique, technique, 0
Sumi™ inks are available as well to tattoo artists. These inks will have a very smooth grey appearance in...
-
Some more tattoo discussion
, Uncategorized, become a tat2, green soap, learn tattoo, learning tattoo, tattoo soap, tattoo spam on forums, tattooing, 0
So you think you have what it takes to be a tattoo artist? Or you want to become a...
-
Contact point materials
, Uncategorized, contact, machine, material, point, spring, tuning, 0
The contact point can be made of different metals. One would assume that the best quality metal would be...
-
What metal is best?
, Uncategorized, experiment, gear, machine, metal, purchase, supply, tuning, 0
Different metals have not only different resistance to electrical current, but different weights as well. Some artists will prefer...
-
Let it dry
, Uncategorized, dry, stencil paper, tattoo stencil, tips, 0
Allow the purple ink to dry. Some artists will immediately begin the tattoo if the placement is acceptable, while...
-
The Dirty Room
, Uncategorized, clean, dirty room, sterilization, 0
Every tattoo studio should have a “dirty” room where biohazardous material is kept and regularly disposed of. In your...
-
How much needle should hang out of the tube?
, Uncategorized, gaps, length, needle, tube, 2
Some artists will tell you to hang your needle out of the tip of the tube about the width...
Recent Comments